d-diot battery powered Multisensors
This battery powered multi-sensor is based on an ATMega328P MCU (Arduino) plus a radio module (NRF24L01 or RFM69) and provides the following functionalities:
- Motion detection (PIR AS312)
- Temperature detection (Si7021)
- Humidity detection (Si7021)
- Light detection (photoresistor)
It is part of the d-diot project, so, as for any other device of the project, a detailed wiki page to build your own copy is available and you can download the model files of the 3d printable plastic case from thingiverse.
The firmware is based on the MySensors library, so the device is compatible with a large number of Home Automation software, including Home Assistant.
The schematics and the details of the pcb are here.
d-diot battery powered Multisensors
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
- Comments(0)
- Likes(3)
More by Francesco Berghi
-
d-diot hub v.3.0 - board B
With this PCB you can build the d-diot hub v.3.0-B, which is:An IR Gateway (transmitter and receiver...
-
d-diot hub v.3.0 - board A
With this PCB you can build the d-diot hub v.3.0-A, which is:A dual wifi MySensors gateway (RFM69 an...
-
USB Smart Hub
With this MySensors node you can turn on/off 3 USB type A ports; the power state of each USB port ca...
-
d-diot multi-purpose IoT pcb
This small PCB (55×35) is born to be a general purpose solution for building any kind of compact wir...
-
d-diot battery powered Multisensors
This battery powered multi-sensor is based on an ATMega328P MCU (Arduino) plus a radio module (NRF24...
-
A 3d printable wifi mood lamp with ESP8266 and WS2812B LEDs
This mood lamp is part of the d-diot project, which is an open project for hobbyist, makers, and eve...
-
-
Helium IoT Network Sensor Development board | H2S-Dev V1.2
91 0 0 -
-
-
-
-
3D printed Enclosure Backplate for Riden RD60xx power supplies
176 1 1
