A 3d printable wifi mood lamp with ESP8266 and WS2812B LEDs
This mood lamp is part of the d-diot project, which is an open project for hobbyist, makers, and everyone interested on home automation. The aim of d-diot is to create an easy, accessible and "privacy friendly" domotics platform for your home.
An overview of the lamp is here, while the detailed build instructions are here.
The firmware is built with ESPHome, which is a great tool that allows you to integrate your devices in Home Assistant, one of the most popular platform for the home automation. The configuration files necessary to build the firmware with ESPHome are here.
If you like this lamp and you want to build your own, remeber that the d-diot forum is the right place to ask for support.
A 3d printable wifi mood lamp with ESP8266 and WS2812B LEDs
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
- Comments(0)
- Likes(3)
- 1 USER VOTES
- YOUR VOTE 0.00 0.00
-
6design
-
3usability
-
3creativity
-
2content
More by Francesco Berghi
-
d-diot hub v.3.0 - board B
With this PCB you can build the d-diot hub v.3.0-B, which is:An IR Gateway (transmitter and receiver...
-
d-diot hub v.3.0 - board A
With this PCB you can build the d-diot hub v.3.0-A, which is:A dual wifi MySensors gateway (RFM69 an...
-
USB Smart Hub
With this MySensors node you can turn on/off 3 USB type A ports; the power state of each USB port ca...
-
d-diot multi-purpose IoT pcb
This small PCB (55×35) is born to be a general purpose solution for building any kind of compact wir...
-
d-diot battery powered Multisensors
This battery powered multi-sensor is based on an ATMega328P MCU (Arduino) plus a radio module (NRF24...
-
A 3d printable wifi mood lamp with ESP8266 and WS2812B LEDs
This mood lamp is part of the d-diot project, which is an open project for hobbyist, makers, and eve...
-
-
-
-
-
3D printed Enclosure Backplate for Riden RD60xx power supplies
154 1 1 -
-
