temp and pingpong PID board
2 Layers PCB 37 x 53 mm FR-4, 1.6 mm, 1, HASL with lead, Red Solder Mask, White silkscreen
This stack on PCB can be used on the CC3220 LaunchXL and you can test heating the Resistor and measure the temperature with the MCP9804
753
0
0
Published: Jan 03,2020
Download Gerber file 6
PCBWay Donate 10% cost To Author
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
Under the
Attribution-ShareAlike (CC BY-SA)
License.
- Comments(0)
- Likes(0)
Upload photo
You can only upload 5 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP
0 / 10000
More by Koen Muilwijk
-
temperature en Pingpong
Educational PCB. To be used to learn control technology. either with PWM warm up the resistor to a c...
-
Autopilot redundant
Redundant power to servo autopilot sailboat
-
RTK-GPS heading
STM32 with possibility to connect two GNSS receivers do do RTK moving baseline vector heading
-
AutoPilot with RTK-Heading
Autopilot with STM32 input is an RTK heading from two GNSS receivers
-
MCU RC BOAT
MCU for an autoilot for an autonomous boat
-
temp and pingpong PID board
This stack on PCB can be used on the CC3220 LaunchXL and you can test heating the Resistor and measu...
-
Sub D9 Breakout Board
Sub D9 Female and Male breakout board
You may also like
-
-
-
kmMiniSchield MIDI I/O - IN/OUT/THROUGH MIDI extension for kmMidiMini
112 0 0 -
DIY Laser Power Meter with Arduino
162 0 2 -
-
Box & Bolt, 3D Printed Cardboard Crafting Tools
156 0 2 -
A DIY Soldering Station Perfect for Learning (Floppy Soldering Station 3.0)
559 0 2
