|
ESP-12 |
x 1 | |
|
BK-18650-PC2 |
x 1 |
ESP12-18650
This ESP-12f development board fits the back of an 18650 battery holder perfectly and features:
* SMD or through hole (2mm pin header attachment) mounting for the ESP12-f module.
* A prototyping area with power rails and pin breakouts.
* Extra pin header breakouts to attach the module to a breadboard instead of a battery holder.
* Bridged solder jumpers (0603) for the relevant pin pull-up/downs "resistors" needed to make the module boot into flash mode.
* Pads to connect up a battery fuse (bridged by default) and resets buttons if needed.
ESP12-18650
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
- Comments(0)
- Likes(0)
- 0 USER VOTES
- YOUR VOTE 0.00 0.00
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
More by Johannes Larsen
-
-
Helium IoT Network Sensor Development board | H2S-Dev V1.2
90 0 0 -
-
-
-
-
-
3D printed Enclosure Backplate for Riden RD60xx power supplies
176 1 1