Fujifilm XE4 Grip
I picked up the Fujifilm XE4 because I couldn't get my hands on the elusive Fujifilm X100VI (curse you Ebay scalpers!), but still wanted a camera with similar characteristics. While I ended up falling in love with this camera, it leaved a lot to be desired in the ergonomics department. I looked up some solutions online and while they existed, they weren't very cheap. Thus, I made this affordable 3D-printable alternative!
Project Video: https://www.youtube.com/watch?v=UdgN1Nkde2w
3D File: https://www.thingiverse.com/thing:6845140
Fujifilm XE4 Grip
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
- Comments(0)
- Likes(1)
More by Jason Wu
-
Fujifilm XE4 Grip
I picked up the Fujifilm XE4 because I couldn't get my hands on the elusive Fujifilm X100VI (curse y...
-
Keyboard PSP Frame
This is a rather niche project that I kicked off after beginning my Japanese immersion learning jour...
-
Motion Activated Trash Can Lid
I've been using the same boring trash bin for the last 6 years, and thought it was time for an upgra...
-
Single-Book Book Stand
This is a bookstand that allows your books to stay standing even when the stand isn't full! Traditio...
-
-
-
DIY Transistor Tester | Build Your Own LCR Meter at Home with Arduino Nano
178 0 1 -
-
ESP32-S3 breakout board for motorizing Iron Man helmets
197 0 2 -
-
-
