MCU PROTO DEV BOARD
MCU DEV BOARD
Every enthousiast need to make is pcb prototype before have tested on its breadboard.
Lamentably, all standard proto board are difficult to use and need to make route with the solder wire or make bridge with the solder.
Everybody knows, each component or pins need to be connected to other, if we need to use it.
It's why this proto board is born.
Each hole, permit to connect directly a wire to make easilly a route or a bridge connection.
The power line is present on the external board to facilitate the connection from the entire board.
Don't hesitate to use it, and accelerate your prototype.
Kind regards to all enthousiast.
MCU PROTO DEV BOARD
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
ESP32-S3 4.3inch Capacitive Touch Display Development Board, 800×480, 5-point Touch, 32-bit LX7 Dual-core Processor
BUY NOW
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
- Comments(0)
- Likes(3)
Log in to post comments.
More by Valerio TRIPICCHIO
-
-
-
Modifying a Hotplate to a Reflow Solder Station
1000 1 6 -
MPL3115A2 Barometric Pressure, Altitude, and Temperature Sensor
543 0 1 -
-
-
V2 Commodore AMIGA USB-C Power Sink Delivery High Efficiency Supply Triple Output 5V ±12V OLED display ATARI compatible shark 100W
1270 4 2 -
How to measure weight with Load Cell and HX711
761 0 3
