HackVlog Hugatry
FINLAND • + Follow
Description
Radius Gauge (1-15mm)
No need for components or soldering. Just order the PCBs and you'll have radius gauge similar to one shown in the video below!
This radius gauge can measure radius of fillets/rounded corners between 1-15mm (1mm steps). In the center of the gauge there are holes for quickly identifying bolts/rods with diameter of 4, 5, 6, 8, 10 or 12mm.
Jun 27,2023
681 views
Radius Gauge (1-15mm)
2 Layers PCB 75 x 74.8 mm FR-4, 1.6 mm, 1, HASL with lead, Green Solder Mask, White silkscreen
Radius gauge is used to measure radius of rounded corners / fillets.
681
1
6
Published: Jun 27,2023
Download Gerber file 3
PCBWay Donate 10% cost To Author
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
Under the
Attribution-ShareAlike (CC BY-SA)
License.
- Comments(6)
- Likes(1)
Upload photo
You can only upload 5 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP
0 / 10000
More by HackVlog Hugatry
-
CH551G Prototyping Board W/USB-C
What?This is handy development board with CH551G, USB-C jack and all the required extra components. ...
-
ATTiny85 Foot Pedal Controller
What?This is simple test circuit for reading the position of old sewing machine foot pedal (low volt...
-
DIY 2S Lithium Battery Protection Module
Important to know, if you order this boardBottom layer doesn't have any exposed copper. There are no...
-
CH551G Based AVR ISP Programmer
Simple AVR ISP programmerMy first AVR programmer was just a parallel port cable with few resistors. ...
-
VGT6250 Ultrasonic Cleaner Replacement Timer
WARNING!This PCB is powered from 5V that comes from the power management board inside the ultrasonic...
-
Microphone preamp with filtered power supply
No pick&place file / BOMDifferent microphones, sound cards, power supplies have differen specifi...
-
Radius Gauge (1-15mm)
No need for components or soldering. Just order the PCBs and you'll have radius gauge similar to one...
-
Protoboard with MCP1700/LM78xx regulator
I designed a prototyping board / perfboard that includes some of the components I've found myself us...
You may also like
-
-
-
-
-
3D printed Enclosure Backplate for Riden RD60xx power supplies
154 1 1 -
-
