|
KiCADKicad
|
SMuFF Mini Relay Board
This is a mini relay board for the SMuFF project. It allows the controller to switch the Feeder stepper motor signals (1A, 1B / 2A, 2B) between the 3D printer and the controller board back and forth.
For printing the 3D printer is controlling the Feeder stepper, on tool changes the SMuFF controller takes over until the tool change has been accomplished.
I made this PCB to get rid of the (in relation) huge Adafruit 4 switch Relay module which works great for this task but makes the enclosure larger than it has to be.
By using an optocoupler, the relay board is fully galvanically isolated and thus protects the I/O port of the controller (STM32 in this case) from being electrically damaged.
Read more about this project in detail here.
SMuFF Mini Relay Board
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
ESP32-S3 4.3inch Capacitive Touch Display Development Board, 800×480, 5-point Touch, 32-bit LX7 Dual-core Processor
BUY NOW
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
- Comments(0)
- Likes(1)
Log in to post comments.
More by Technik Gegg
-
SMuFF-Backbone PCB
This PCB is an add-on for the SMuFF project.Learn more about this project in general here on my webs...
-
Smart Filament Buffer
This PCB brings the "S" into the SFB (Smart Filament Buffer). It combines a Filament-Buffer needed f...
-
SMuFF-Connector PCB
This PCB is an add-on for the SMuFF project.Learn more about this project in general here on my webs...
-
SMuFF-Ifc2 PCB for ESP32
This little adapter PCB is used in the SMuFF-Ifc2 project for the ESP32 variant.The SMuFF-Ifc2 is ba...
-
SMuFF Mini Relay Board
This is a mini relay board for the SMuFF project. It allows the controller to switch the Feeder step...
-
Modifying a Hotplate to a Reflow Solder Station
438 0 4 -
MPL3115A2 Barometric Pressure, Altitude, and Temperature Sensor
260 0 1 -
-
-
V2 Commodore AMIGA USB-C Power Sink Delivery High Efficiency Supply Triple Output 5V ±12V OLED display ATARI compatible shark 100W
681 4 2 -
How to measure weight with Load Cell and HX711
524 0 3 -
-
Instrumentation Input, high impedance with 16 bit 1MSPS ADC for SPI
603 1 0
