This is the original COREi64 Ultimate 64 installation kit for the Commodore 64c.

With Gideon's recent release of the Ultimate64 FPGA computer main board, it became quickly apparent that a set of 3D printed parts were needed to complete a quality installation of this board in a 64c Commodore case. This part set is compatible with both the regular and Elite versions of the Ultimate 64.

The components that comprise the complete kit includes left and right keyboard brackets, mainboard support bracket, userport bracket and TWO different styles for the power connector and power button area. You may pick and choose what you'd like to order to suit your installation needs. These two styles of power plates are as follows:

1. A single power plate that covers the void around the power connector and pin style power button that comes installed on your Ultimate 64.
2. A separate power plate that covers the void around the power connector only, and a separate large power button that slips over the factory pin momentary switch installed on the board, filling the entire switch hole opening.

For the power button, there are two options.

1. Is the plain power button that fits over the U64 power switch.
2. The second is the power button with a hole to allow you to insert an LED. This will allow you to illuminate your button through the LED connector on the U64 board.

This is a brief description of each item in the kit:

1. Left keyboard bracket (M3 Heatset is required)
2. Right keyboard bracket (M3 Heatset is required)
3. Center PCB support bracket
4. Power connector/Power button plate (short)
5. Power connector/Power button plate (long)
6. Userport plate

This installation set of parts is compatible with the Gideon Ultimate64 standard and elite mainboards, and is compatible with the 64c, kickstarter and post-kickstarter cases.

Required heatsets and screws are as follows (and the responsibility of the purchaser to order and install).

Heatset (2 required for keyboard brackets)

https://www.mcmaster.com/catalog/94180A331

Screw (2 required for keyboard brackets)

https://www.mcmaster.com/91290A113

Stainless steel washers (2 required for keyboard brackets)

https://www.mcmaster.com/catalog/93475A210

Note: Heatsets should be melted into the keyboard brackets only if you're having these manufactured in ABS or PLA. If you're resin printing these brackets, then you should superglue the heatsets into the holes in the top of the keyboard brackets. You may need to drill out the heatset holes a little so the heatsets will be snug when inserted. The superglue will hold them in place. Ensure you don't get any superglue on the thread.

Licence Notes: You may feel free to order these brackets and sell them anywhere you'd like. They need not be only purchased for personal use. Commercial use is permitted. Attribution must be added to your for sale listings should you decided to sell these commercially.