Top Solder Mask
Top Overlay
Top Copper Layer
Armcontroller
### DESCRIPTION
PCB for a simple wired controller used to control 4 seperate motors. In this project i use this PCB for a controller that will be used to controll a robotiv arm
### TECHNICAL DETAILS / COMPONENTS
Materials:
- 8 three position switches
- 3 feet of wires
- a 3.7 volt lithium ion battery
### LEARN / TOPIC / BUILD INSTRUCTIONS
first solder 3 postion switches into the 8 spots available for the switches. Once that is complete solder the wires for the motors into the 8 holes available for the + and - of each motor. Finally solder the wires for the battery into the 2 holes near the battery symbol.
Armcontroller
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
- Comments(0)
- Likes(0)
Log in to post comments.
More by Joshua Donald
-
DIY Laser Alarm
A laser triggered home defense system
-
Night Vision Glasses
### DESCRIPTIONHow to make Sonar goggles / night vision goggles at home using an arduino and sensors...
-
Armcontroller
### DESCRIPTIONPCB for a simple wired controller used to control 4 seperate motors. In this project ...
-
DIY amplifier circuit
n this tutorial we will be building a simple boombox speaker that plays loud music and has great qua...
-
How to measure weight with Load Cell and HX711
176 0 2 -
-
Instrumentation Input, high impedance with 16 bit 1MSPS ADC for SPI
368 0 0 -
RGB LED Matrix input module for the Framework Laptop 16
614 0 2 -
-
