aLed Controller v2
aLed Controller is an analog leds controller for the smart home. It was designed to run with Home Assistant using ESPHome and features:
- Six analog channels. (Can control a single CCTRGB or RGBW strip, up to two RGB strips, up to three CCT strips, or up to six single color strips).
- Based on ESP32-WROOM-32.
- Runs EPSHome (or you can flash it with whatever firmware makes you happy)
- Changeable fuse
- [Optional] INA226 sensor (a current shunt and power monitor).
- [Optional] Ambient light sensor.
- [Optional] PCB temperature sensor (can be handy if you plan to run high power load).
- [Optional] SHT40 temperature and humidity sensor.
- [Optional] DS18B20 temperature sensor (cheaper, easier to get hold of, and solder compared to SHT40).
- [Optional] Outputs for up to 3 external buttons.
- [Optional] I2C bus output for plugging an external sensor.
- [Optional] Connector for ePaper display.
The controller works with 5-24v input. Positive output lines are protected by a replaceable fuse.
3D printed enclosure is available for the controller.
aLed Controller v2
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
- Comments(5)
- Likes(4)
- Engineer Aug 26,2024
- Engineer Jul 23,2024
- Mariusz Skupiński Feb 24,2024
- Daniel K Feb 15,2024
- 1 USER VOTES
- YOUR VOTE 0.00 0.00
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
-
10design
-
10usability
-
10creativity
-
10content
More by dls dlsNet
- Wi-Fi Garage Door Controller with Dual Sensor Integration Key Capabilities:1. Enhanced Door Status Monitoring:• Open/Closed Sensors: The controller is equippe...
- aLed Controller v2 aLed Controller is an analog leds controller for the smart home. It was designed to run with Home As...
- ICS43434 Microphone Board ICS-43434 mic board. Created to use with audio-reactive WLED. Stencil is not needed but is recommend...
-
-
-
kmMiniSchield MIDI I/O - IN/OUT/THROUGH MIDI extension for kmMidiMini
124 0 0 -
DIY Laser Power Meter with Arduino
173 0 2 -
-
-
Box & Bolt, 3D Printed Cardboard Crafting Tools
163 0 2 -