Arduino UNO×1USB-A to Mini-USB Cable×1Breadboard (generic)×1Buzzer×1

ABOUT THIS PROJECT

This is tutorial to help you understand ultrasonic and buzzer and go deeper into learning Arduino, follow these steps and give me feedback please.

I'm making it to help my cousin in his school project.

Step 1: Prepare your material and tools

PREVIOUS

NEXT

1

2

3

4

5

1. Test Board

2. Ultrasonic sensor

3. Arduino cable

4. +5V buzzer

5. Male to male pins

6. Arduino uno board

Tools and materials are shown in the pictures.

Step 2: Connect your circuit

PREVIOUS

NEXT

1

2

Connect the Buzzer positive terminal to the Arduino pin 2 and the negative terminal to the Gnd. Connect the VCC pin of ultrasonic to +5v pin and the Gnd to the ground.

Connect trig pin to pin 10 and echo pin to pin 9.

The pictures shows you the connection.

Step 3: Load the code to your Arduino

PREVIOUS

NEXT

1

2

You can find code in codebender.cc here, it is well described and commented. This is copy of the code any way.

/*

This code should work to get warning cross the buzzer when something be closer than 0.5 meter

Circuit is ultrasonic sensor and buzzer +5v and Arduino uno is used

a_atef45@yahoo.com

www.zerosnones.net

+201153300223

*/

// Define pins for ultrasonic and buzzer

int const trigPin = 10;

int const echoPin = 9;

int const buzzPin = 2;

void setup()

{

pinMode(trigPin, OUTPUT); // trig pin will have pulses output

pinMode(echoPin, INPUT); // echo pin should be input to get pulse width

pinMode(buzzPin, OUTPUT); // buzz pin is output to control buzzering

}

void loop()

{

// Duration will be the input pulse width and distance will be the distance to the obstacle in centimeters

int duration, distance;

// Output pulse with 1ms width on trigPin

digitalWrite(trigPin, HIGH);

delay(1);

digitalWrite(trigPin, LOW);

// Measure the pulse input in echo pin

duration = pulseIn(echoPin, HIGH);

// Distance is half the duration devided by 29.1 (from datasheet)

distance = (duration/2) / 29.1;

// if distance less than 0.5 meter and more than 0 (0 or less means over range)

if (distance <= 50 && distance >= 0) {

// Buzz

digitalWrite(buzzPin, HIGH);

} else {

// Don't buzz

digitalWrite(buzzPin, LOW);

}

// Waiting 60 ms won't hurt any one

delay(60);

}

this is my project about which i wanted to make please support.