I used a 0.25mm pad size blind via on a BGA pad with a 0.25mm size. I set a 0.1mm B/B stagger clearance in the physical constraints, but I am still getting a DRC error: "Minimum blind/buried via stagg...
I have a project which contains an IC that requires 2 guard traces between some of the pins. Since the ICs Pin pitch is 0.65mm/25.6mil this would require the usage of trace spacing/width smaller than ...
I have been searching for ways to jam a wifi connection of a 2.4ghz robot with it's control hub (REV). Sadly all the wifi jammers I found were way too expensive and would not fit my simple usecase. I ...
