I'm using Altium 20. I have a schematic open on one monitor and PCB editor open on another.In my schematic editor I cannot seem to open my properties panel. It says it's active (ticked in the ...
I'm designing a PCB which is going to have some nets at 100V. I have created a net class "100V" for that and I would like to highlight all pads/lines in this class.I tried doing this so ...
All my components show they have violations. When I check them they all state something about a Room Violation. Do I have to have one? Thanks for any help.
If I route track to the left pad, the right pad along with the portion of track connecting to it disappears.I think I remember doing something in settings and that issue got resolved, but I forgot wer...
I have a 4 layer board with internal power layers. I'm trying to add a decoupling cap to a DIP IC. The problem I 'believe' I have is that the 10 Pin is set to Vcc net and Altium is c...
I am trying to place a capacitor (right) next to an amplifier (left). But cannot move it closer than 0.25mm, although I set the horizontal component spacing to 0.0mm and pad to pad clearance is 0.15mm...
When I try to lay out my PCB I sometimes get these diagonal lines going through a component.I click on the component but can't find any details or anything wrong. What does this mean and is it any...
Hi, I have 6 Un-Routed Net Constraint errors, despite that all of them are connected correctly.Things I have tried but did not work:- Reconnecting the pad with the trace- Re-routing the complete trace...
