May 30,2019
3,851 views
end-flag
  • Comments(10)
  • Likes(11)
Upload photo
You can only upload 5 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP
0 / 10000
  • Hi djbase! I ordered this board but the board I received does not have any solder pads on the underside for the resistors R2-R19 as shown in the pictures. Is this intentional or this a bug in the gerber file? Thanks!

    AMIGAworld 2020-08-20 14:47:33Reply

    Thats because you might have Revision A which does not have these extra Resistors.

    Steve 2021-03-01 20:21:50Reply

    Ok. Thank you! Are the resistors strictly needed or will the board revision A still work correctly?

    AMIGAworld 2021-05-24 01:02:08Reply

    The resistors are just pullups required by some older revision of the A500 for stability.

    Reply
  • hi , my boards are with 2 pin jumper , is it new version or ?

    Reply
  • Hi,with this kickstart the amiga 500 case closes perfectly?

    Reply
  • Hi, On the Bom list above R2-R19 are 2.2K, but on your website they are 4.7K. Which one do i have to use. And can i use the 74HC00 instead of the 74LS00 which is very hard to find/buy. (Discontinued)

    AMIGAworld 2020-09-05 02:47:42Reply

    Should be 4.7k and HC/HCT is also fine.

    Reply
  • Hi, Does it work for Amiga 500 Rev5 ? Thanks

    AMIGAworld 2020-07-30 03:56:08Reply

    Should work with Rev5 too

    Reply
VOTING 2 votes
  • 2 USER VOTES
8.63
  • YOUR VOTE 0.00 0.00
Engineer
Engineer
  • 10
    design
  • 10
    usability
  • 10
    creativity
  • 10
    content
10.00
Engineer
Engineer
  • 7
    design
  • 7
    usability
  • 7
    creativity
  • 8
    content
7.25

More by AMIGAworld

You may also like