Faruk Soares Correia
MOZAMBIQUE • + Follow
Description
NodeMCU32 Shield
This board is for a NODEMCU32, you should be able to add pull down or pull up resistors for the GPIO pins, there is also place for Logic Level Converters, input it's 5V only. There are 3V and GND pins for each GPIO pin, but be aware of the MCU32 power limitations.
Dec 12,2021
1,356 views
end-flag
NodeMCU32 Shield
This is a shield for NodeMCU32 shield.
1356
4
0
10.00 (1)
Published: Dec 12,2021
Download Gerber file 18
PCBWay Donate 10% cost To Author
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
Under the
Attribution-ShareAlike (CC BY-SA)
License.
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
ESP32-S3 4.3inch Capacitive Touch Display Development Board, 800×480, 5-point Touch, 32-bit LX7 Dual-core Processor
BUY NOW
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
Topic
- Comments(0)
- Likes(4)
Log in to post comments.
Upload photo
0 / 10000
VOTING
1 votes
- 1 USER VOTES
10.00
- YOUR VOTE 0.00 0.00
-
10design
-
10usability
-
10creativity
-
10content
10.00
More by Faruk Soares Correia
-
ESP32-S3 ALED + Stepper + RGB Strip V2
NOTE: I made this board to suit my needs, and decided to share the board in case someone needed. If ...
-
RGBW 5V/4W Addressable LED TM1814 Chip
A small PCB for addressable 4W RGBW LED 5V input with TM1814 Chip, can be used to create color chang...
-
ESP32 Starlight Ceiling Board for ESPHOME and WLED
Use a ESP32 Devkit-C, to drive 2 RGBW connections, an Addressable LED, a spot for a I2S Microphone a...
-
NodeMCU32 Shield
This board is for a NODEMCU32, you should be able to add pull down or pull up resistors for the GPIO...
-
Extruder PCB
Use long screws and spacers to attach the PCB to the back of your extruder stepper, use a 20 pin mol...
You may also like
-
-
-
Modifying a Hotplate to a Reflow Solder Station
748 1 5 -
MPL3115A2 Barometric Pressure, Altitude, and Temperature Sensor
404 0 1 -
-
-
V2 Commodore AMIGA USB-C Power Sink Delivery High Efficiency Supply Triple Output 5V ±12V OLED display ATARI compatible shark 100W
967 4 2 -
How to measure weight with Load Cell and HX711
637 0 3
