Solar Einspeise-Regelung
Cooperation between UTUBERLARS and SmartHome yourself.
This PCB is designed to switch the output voltage of your solarpanel between your battery-charger and your inverter to use your solarpower most efficient.
If your battery is full, the pcb send power to the relays-output to switch solarpower to the inverter. If the battery get below the configurable minimum voltage, it switches back to charge your battery until it reaches the also configurable maximum.
Utuberlars:
https://www.youtube.com/channel/UCWzgOrFuh82znXetsW3pmAA
https://www.guerilla-stromer.de/
SmartHome yourself:
https://www.youtube.com/SmartHomeYourselfDe_DIY
BOM:
https://smarthomeyourself.de/hc_downloads/einspeise_regelung_BOM.csv
Video:
https://www.youtube.com/channel/UCWzgOrFuh82znXetsW3pmAA
this product is for testing purpose only!
Solar Einspeise-Regelung
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
- Comments(0)
- Likes(4)
More by Daniel Scheidler
-
Solar Einspeise-Regelung
Cooperation between UTUBERLARS and SmartHome yourself.This PCB is designed to switch the output volt...
-
Barcode scanner made for ESPHome
The project was created to fill my shoppinglist by scanning ean/gtin codes.All project informations ...
-
Neopixel-Ring RGB Clock (with ESPHome for Home Assistant)
RGB-Clock with ESPHome for Home Assistant.Use Neopixel-Ring with 60 LEDs to show current Time.To dis...
-
Smart Garage-Door control with animated RGB-LED (with or without Home Assistant)
Standalone:automated RGB-LED-Animation when door is opening / closingAdditional features when using ...
-
FPV Laptime Tracker
The Project is to track laptimes of FPV Racing Drones in races. No modification of the FPV Copter is...
-
Integrate every doorbell in Home Assistant
This PCB was designed to integrate my old doorbell into Home Assistant.The board uses the transforme...
-
RGB LED Ambiente light
Panel with 3 PCBs of my ambience rgb led light with on/off- and color-switch button.More Details abo...
-
RGB LED Stairlight
This is my new stairlight with RGB-LEDs. Motion-Sensor on top and bottom of the stairs to autoswitch...
-
8 in 1 Sensor for Home Assistant
This PCB is an 8 in 1 Sensor for Home Assistant. The NodeMCU is flashed with ESPHome with the follow...
-
12V RGB Stripe Controller WiFi (for Home Assistant / ESPHome)
This PCB is designed to control non-adressable RGB-LED-Stripes in Home Assistant with ESPHome. Full ...
-
RF to MQTT Bridge for Home Assistant
THIS PCB SEEMS TO BE UNSTABLE! Will NOT be continuedPCB for OpenMQTTGateway as RF to MQTT Bridge for...
-
LED-stairlight (without fade) by SmartHome yourself
This PCB is for my motion-controlled stairlight. This PCB is desigend for up to 16 stair steps.Motio...
-
LED-stairlight (with fade) by SmartHome yourself
This PCB is for my motion-controlled stairlight. This PCB is desigend for up to 16 stair steps.Motio...
-
-
Helium IoT Network Sensor Development board | H2S-Dev V1.2
91 0 0 -
-
-
-
-
3D printed Enclosure Backplate for Riden RD60xx power supplies
176 1 1
