Tim Jackson
UNITED KINGDOM • + Follow
Description
Tim's DC Motor Driver X6 Mk2
This board was designed to drive the motors controlling the arms on my robot TIM-01.
I have a blog on the progress of my robot here:
Robot-TIM-01
It's six basic Half-Bridges, with a few extra transistors to enable single wire control of the motors.
There are pinouts for feedback from stops and encoders.
There are links to share motor power from a single input.
An example of single wire control can be found here:
Pen Mechanism
and
Tim's Linear Slide
Code
https://robot-tim01.blogspot.com/2021/01/dc-motor-driver-x6.html
Schematic and Layout
https://robot-tim01.blogspot.com/2020/11/new-arms.html
Jan 12,2021
1,015 views
Tim's DC Motor Driver X6 Mk2
A small Driver board for controlling six DC Motors.
5v logic, motors 5-12 V 500 mA max.
The board was designed for my Robot project TIM-01
1015
1
0
Published: Jan 12,2021
Download Gerber file 1
PCBWay Donate 10% cost To Author
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
Under the
Attribution-ShareAlike (CC BY-SA)
License.
Topic
- Comments(0)
- Likes(1)
Upload photo
You can only upload 5 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP
0 / 10000
More by Tim Jackson
-
Tim's I2C Dual Motor Driver [Version 2]
This is Version 2 of my previous Tim's I2C Dual Motor Driver.This supersedes this Project. Tim's I2C...
-
Tim's Mini Plotter 2
This is a PCBWay PCB Version of mini plotter I did quit a while ago, my original mini plotter I made...
-
Tim's I2C Dual Motor Driver
This board has been SupersededThe version 2 can be found here:Tim's I2C Dual Motor Driver [Version ...
-
Tim's Pie Divider
Tim's Pie DividerWhen that pie comes out of the oven and your tummy rumbles, who gets the largest pi...
-
Tim's I2C Intelligent DC Motor Driver
I am working on a project that needs about six Motors. There are many DC Motor Drivers available, Bu...
-
Tim's PTC Hot Plate Controller [Fused version]
This is a fused version of this: Tim's PTC Hot Plate ControllerInstructable at: Tim's Hot PlateFor c...
-
Tim's PTC Hot Plate Controller
This is a for a DIY Hot Plate, for soldering SMD to PCBs.The heater element that it controls are the...
-
TIM-01 EYES
This is a module to give my robot TIM-01 Eyes.With many projects controlled by an Arduino or similar...
-
Tim's DC Motor Driver X6 Mk2
This board was designed to drive the motors controlling the arms on my robot TIM-01.I have a blog on...
You may also like
-
-
-
-
-
3D printed Enclosure Backplate for Riden RD60xx power supplies
154 1 1 -
-
