Hi,I'm looking for build a 4 layers flex rigid pcb,at one end the Rigid part and on the other end the flex part with components.To do this i understand thal i should seperate the rigid from the fl...
I searched everywhere and watched many eagle tutorials, but I couldn't find out how to place circle and square through hole solder pads.In the Eagle parts list, I only found the octagon solder pad...
Should I link up these ground signals or leave them?PCB I'm working on has a main board and then smaller secondary boards which contain external components. Everything is isolated and has its own ...
As it shows, there are two isolated areas of the ground pour. I'm using Eagle, so when I do the pour it does not place in these type of areas unless I explicitly place a via where the bottom...
Is it a component? Came across it when converting my schematic to PCB. How do I get this in my schematic when I am supposed to recreate this schematic in Eagle?
Hi all,I'm working on a design that uses a power switch(picture showed below) with a 6-UFBGA package to switch between USB and battery backup power. I will be placing the components by hand a...
Hi everyone,I'm making a device with an SD card slot. The SD card holder is just a surface mount metal shell, and it has 4 foot pads that solder down, and are not electrically connected. I'd l...
Hola, gerber generado por eagle, no aparecen las perforaciones en el visor de gerbers (en PCBway, en otros sí). A que se debe?Hay un proyecto que subieron al concurso que no es de su autoría (conozco ...
