Top Solder Mask
Top Paste Mask
Top Overlay
Top Copper Layer
Mill Layer
Bottom Solder Mask
Bottom Paste Mask
Bottom Overlay
Bottom Copper Layer
NC Drill
Bottom
Shield_DMM
This miliohm meter can be very useful in some cases - it can be used during debugging of some electronics devices which have short connections inside, to locate defected capacitors, resistors, chips..etc.By scanning the area around the short it cab be easily located the burned out device measuring the resistance of the conductive PCB tracks and finding the place with minimum resistance. If you are interested more about this process - you can find a lot of videos about.
All neededed information can be found under this link: http://www.instructables.com/id/Miliohm-meter-Arduino-Shield-Addendum/
Shield_DMM
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
- Comments(0)
- Likes(1)
More by penev_milen
-
LORADUINO USB to LORA converter
The Arduino is widely used platform for lot of applications. Despite its all advantages in some case...
-
LORADUINO Main board
The Arduino is widely used platform for lot of applications. Despite its all advantages in some case...
-
Arduino Mega Rev.3 with CH340G
Because the CH340G chip is cheaper and easy to find I decided to modify the design of the Arduino Me...
-
Phone call detector
All needed information about the device can be found in the Instructables site : https://www.instruc...
-
White noise generator
This board can be used for white noise generation. Its principle of work is based on the noise gener...
-
Joule Thief Power Bank
All project data can be found under the following link : https://www.instructables.com/Joule-Thief-P...
-
Arduino nano to uno adaptor board
Arduino Nano is a nice, small and cheap member of the Arduino family. It is based on the Atmega328 c...
-
Shield_DMM
This miliohm meter can be very useful in some cases - it can be used during debugging of some elec...
-
FM Radio
All needed information can be found under this: http://www.instructables.com/id/Tiny-FM-radio/
-
-
-
-
-
3D printed Enclosure Backplate for Riden RD60xx power supplies
154 1 1 -
-
