PCB Prototype the Easy Way

Full feature custom PCB prototype service.

Help Center
Sending a message
9:00 - 23:00, Mon.- Sun. (GMT+8)
Service hotlines
+86 571 8531 7532

9:00 - 18:00, Mon.- Fri. (GMT+8)

9:00 - 12:00, Sat. (GMT+8)

(Except Chinese public holidays)

How can we help?

How to generate Gerber files from ALtium Designer (DXP)

Version number: 23.5.1

Gerber Files

Select the menu bar, click "File"->"Fabrication Outputs"->"Gerber Files", as shown in the figure below.

Altium_Designer_1.png

After clicking, the Gerber Setup interface will appear. Refer to the red boxes in the figure below to select the Layers to plot page, and click "Plot Layers"->"Select Used".

Altium_Designer_2.png

On the Advanced page, select as shown below.

Altium_Designer_3.png

Click Apply, and the pop-up .Cam project file can be closed directly without saving.

Altium_Designer_4.png

Drill Files

Select the menu bar, click "File"->"Fabrication Outputs"->"NC Drill Files".

Altium_Designer_5.png

After clicking, the NC Drill Setup interface will pop up, select as shown below and click OK.

Altium_Designer_6.png

Import Drill Data Page appears, keep the default setting and click OK.

Altium_Designer_7.png

The pop-up .Cam project file can be closed directly without saving.

Altium_Designer_8.png

So far, both Gerber files and drill files have been exported. As shown below.

Altium_Designer_9.png

Last updated on 31/05/2024
Comments (0)
This message here is only a suggestion supplement to the above content, and does not for trading operations such as orders. If you have any urgent questions or order issues, please contact your sales rep.
Upload photo
You can only upload 5 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP
0 / 10000